RESEARCH ON THE TECHNOLOGY OF MANUFACTURING A HEAT EXCHANGER ASSEMBLY USED AS A PART OF AN ELECTRICALLY DRIVEN CENTRIFUGAL AIR COMPRESSOR CCAE 15-300

Authors

  • Andrei Mitru National Research and Development Institute for Gas Turbines COMOTI
  • Mircea Mitru National Research and Development Institute for Gas Turbines COMOTI
  • Augustin Semenescu University Politehnica of Bucharest

Keywords:

soldering. heat exchanger assembly, manufacturing technology, centrifugal air compressor

Abstract

The paper presents the technical and operational characteristics of the heat exchanger assembly for a centrifugal air compressor CCAE 15-300. The structure and the component parts of the heat exchanger assembly are shown in the paper. The basic materials and the main characteristics of the components are described in the paper. The main objective of this article is represented by the description of the technology for manufacturing the components and the heat exchanger assembly by soft soldering with tin.

References

Downloads

Published

2021-09-30

Issue

Vol. 25 No. 3 (2021): Nonconventional Technologies Review

Section

Articles

How to Cite

RESEARCH ON THE TECHNOLOGY OF MANUFACTURING A HEAT EXCHANGER ASSEMBLY USED AS A PART OF AN ELECTRICALLY DRIVEN CENTRIFUGAL AIR COMPRESSOR CCAE 15-300. (2021). Nonconventional Technologies Review, 25(3). http://www.revtn.ro/index.php/revtn/article/view/348

Most read articles by the same author(s)

1 2 > >>