INFLUENCE OF HEAT TRANSFER ON THE NOZZLE OF DIFFERENT MATERIALS FOR THE E3D V6 SOLUTION
Keywords:
polylactic acid (PLA), Acrylonitrile Butadiene Styrene (ABS), thermoplastic polymer, heat transfer, heat transfer simulation
Abstract
The present study approaches comparative research on the thermal transfer between the components of the plasticizing part of the PLA and ABS type material respectively. It can be observed that besides the fact that the temperature difference between the heating part generated with an electric resistance placed in the heated block and the nozzle is not very large, the thermal transfer is relatively linear with small temperature losses.
References
1. Vasilescu, M.D., Influence of technological parameters on the structure and deformation of flat or round parts generated by DLP 3D printing, Nonconventional Technologies Review, Sibiu Vol. 23, Iss. 4, (Dec 2019): 56-61, (2020).
2. Tulcan, A.; Vasilescu, M.D.; Tulcan, L. Comparative Study of the Influence of Bio-Resin Colour on the Dimension, Flatness and Straightness of the Part in the 3D Printing Process. Polymers 2021, 13, 1412. https://doi.org/10.3390/polym13091412
3. Vasilescu, M.D., Mihai Titu - Comparative study between the generations of 3D printed parts by thermoplastic or optical polymerization, Nonconventional Technologies Review, 2017, 2359-8646, vol.3, 18-23 pag, (2019).
4. Vasilescu, M.D. - Influence of constructive and technological parameters at generated spiral parts with DLP 3D printing process, Revista de materiale plastice, ISSN 0025 / 5289, 4/2019, 56, 801 – 811 pag,
2. Tulcan, A.; Vasilescu, M.D.; Tulcan, L. Comparative Study of the Influence of Bio-Resin Colour on the Dimension, Flatness and Straightness of the Part in the 3D Printing Process. Polymers 2021, 13, 1412. https://doi.org/10.3390/polym13091412
3. Vasilescu, M.D., Mihai Titu - Comparative study between the generations of 3D printed parts by thermoplastic or optical polymerization, Nonconventional Technologies Review, 2017, 2359-8646, vol.3, 18-23 pag, (2019).
4. Vasilescu, M.D. - Influence of constructive and technological parameters at generated spiral parts with DLP 3D printing process, Revista de materiale plastice, ISSN 0025 / 5289, 4/2019, 56, 801 – 811 pag,
Published
2023-12-29
How to Cite
Luca, D. (2023). INFLUENCE OF HEAT TRANSFER ON THE NOZZLE OF DIFFERENT MATERIALS FOR THE E3D V6 SOLUTION. Nonconventional Technologies Review, 27(4). Retrieved from https://www.revtn.ro/index.php/revtn/article/view/441
Section
Articles
Copyright (c) 2023 Doru Alexandru Luca
This work is licensed under a Creative Commons Attribution-NoDerivatives 4.0 International License.
